Manuals, Firmware and Config Files for in2digi D-MB-2 DAB tuner
Please make sure that you only install firmware from this page on the D-MB-2 system ONLY
As part of the installation procedure, you must put the correct firmware and the correct configuration file for your vehicle onto a USB memory device and update the D-MB-2 for it to function correctly. The D-MB-2 Antenna voltage is set at 8Volts. If you need the unit not to supply an antenna phantom feed, please install the configuration file before plugging the antenna in. Please note that if no config file is shown for your system, then there are no configurables.
Please read the details of the update procedure in the manual, AND include both the firmware and the config file (if needed) on the USB memory stick.
Some vehicles may require you to lock the car, wait 2 minutes and open the car again before the DAB unit is visible.
After a successful install the update file(s) are renamed on the USB stick.
Manuals
D-MB-2 Installation Manual (PDF)
D-MB-2 Firmware Update Guide (PDF)
Video: D-MB-2 Firmware Update.
The instructions for using Native DAB versions are in the Comand/Audio manual in your vehicle.
Firmware
You will probably need to install firmware on all new installations, and we recommend installing firmware if you have any issues before contacting us. Please read the Firmware Update guide above and watch the video if you have any concerns.
Release Firmware for NTG4.5 Native (including Service Following)
We recommend that you right click on the link(s) below and save directly to the USB memory stick having formatted it first.
Download Firmware Version 075 (NTG4.5 systems) (Recommended Release @ 14/Feb/2019)
Release Notes for NTG4.5 release V075.
Release Firmware for NTG2.5, NTG3, NTG3.5 (beta), NTG4, NTG4-W212 Native (including Service Following)
We recommend that you right click on the link(s) below and save directly to the USB memory stick having formatted it first.
